You can expect up to a 20% increase in thrust from this pump tuning kit. Get the most from your pump by taking out the additive effect of stacked tollerences inherent in all assemblies. Each of the components in your pump assembly have a +/- tollerence from each respective manufacturing process. A pumps performance is increased by minimizing the gap between the pump wall and the impeller blades. This kit allows you to test a sequesnce of three wear rings that are all .5mm increments thicker than the previous, with the first being .5mm thicker than your stock wear ring. You chose the wear ring that allows the smallest gap without the impeller touching the ring and your pump is tuned! It is that simple and you will notice the difference - guaranteed! ***Important*** You will need to install a PBBR kit or block off your stock bilge in order to realize the increased thrust potential of this upgrade.
2 pack - Stock tail bushing for all Thrasher versions
Stock wear ring for Thrasher V1 and V2
Compatable with V1 and V2 Thrasher Jet Boats, these extremely rugged protectors are made from 18 gauge stainless steel sheet. These parts will take a beating and will allow you to run your Thrasher in shallow water over rock and protect your jet drive during even the hardest bashing sessions.
Stock servo motor for Thrasher V1 and V2. Includes horn and stainless steel mounting screws.
This drive shaft seal is located between the pump body and the motor mount to significantly reduce the flow of water into the hull. One seal is used per boat. Includes two seals.
Add a chrome window to your V1 or V2 Thrasher's windshield area for a sharp looking option! As seen on RC Adventures "Pretty in Pink" THRASHER UNBOXiNG!.
Note: V3 comes standard with a "digital reflection" windshield graphic.