2 pack - Stock tail bushing for all Thrasher versions
Thrasher V1 and V2 Wear Ring
Stock wear ring for Thrasher V1 and V2
Stainless Steel Jet Protector V1/V2
Compatable with V1 and V2 Thrasher Jet Boats, these extremely rugged protectors are made from 18 gauge stainless steel sheet. These parts will take a beating and will allow you to run your Thrasher in shallow water over rock and protect your jet drive during even the hardest bashing sessions.
Thrasher V1 and V2 Steering Servo Motor
Stock servo motor for Thrasher V1 and V2. Includes horn and stainless steel mounting screws.
Drive Shaft Seal - 2 pack
This drive shaft seal is located between the pump body and the motor mount to significantly reduce the flow of water into the hull. One seal is used per boat. Includes two seals.
Note: V3 comes standard with a "digital reflection" windshield graphic.
Steering Nozzle Thrasher V1 and V2
Stock steering nozzle for Thrasher V1 and V2
Billet Aluminum Alloy Impeller V1 and V2
CNC Machined 6061-T6 Aluminum Alloy Impeller. These high performing impellers are designed to maximize pump performance. Made in the USA, machined to the highest quality standards and finished with an anodized surface to increase resistance to corrosion and wear.
Thrasher Fast Plane Ride Plate - V1 and V2
This is a ride plate that holds the bow of your Thrasher down at top speed. These attached very easily from the outside of the boat with a single screw. This upgrade will make your hull plane out very quickly, keep your pump in the water and hooked up more often for increased speed and handling. Improved cornering with reduced slide is also achieved with this simple option.
Thrust Nozzle with Tail Bushing - V1 and V2
Stock Thrust Cone with tail bushing for Thrasher V1 and V2
Sponson Fins - Set of 4
This is a complete set of 4 sponson fins (2 port and 2 starboard) for Thrasher Jet Boats. If you are adding sponson fins to a Thrasher that does not already have a sponson fin kit installed, you will need to purchase a sponson fin kit, which includes these fins as well as mounting hardware.
Thrasher V1 and V2 Pump Tuning Kit
You can expect up to a 20% increase in thrust from this pump tuning kit. Get the most from your pump by taking out the additive effect of stacked tollerences inherent in all assemblies. Each of the components in your pump assembly have a +/- tollerence from each respective manufacturing process. A pumps performance is increased by minimizing the gap between the pump wall and the impeller blades. This kit allows you to test a sequesnce of three wear rings that are all .5mm increments thicker than the previous, with the first being .5mm thicker than your stock wear ring. You chose the wear ring that allows the smallest gap without the impeller touching the ring and your pump is tuned! It is that simple and you will notice the difference - guaranteed! ***Important*** You will need to install a PBBR kit or block off your stock bilge in order to realize the increased thrust potential of this upgrade.
Esc for Thrasher V1 and V2 (2s-6s battery format)
Thrasher V1 and V2 ESC
Thrasher V1 and V2 lid with captive screw and lid pin
Thrasher V1 and V2 lid with captive screw and pin. White only, graphics sold separately.