Tail Bushings - 2 Pack

$19.99

2 pack - Stock tail bushing for all Thrasher versions

Thasher 27" Jet Boat Diverter with tail bushing

Thasher 27" Jet Boat Diverter with tail bushing

$19.99

Diverter with tail bushing installed (also fits V3)

Billet Aluminum Impeller, Thrasher 27" Jet Boat, 26mm pitch, 3 blade

$79.99

CNC machined billet aluminum impeller for Thrasher 27" Jet Boat, 26mm pitch

V3 Nose Protector

$19.99

The V3 nose protector protects the very tip of the bow at the hull rim just above the bow armor. This part comes standard on all new Thrasher V3s and can be added to older Thrasher V3 Jet Boats. Not only does this part at protection against future impacts to the nose, but it will restore the look of a V3 that has had some nose damage.

Drive Shaft Seal - 2 pack

$19.99

This drive shaft seal is located between the pump body and the motor mount to significantly reduce the flow of water into the hull. One seal is used per boat. Includes two seals.

Thrasher 27" Jet Boat Wear Ring

$19.99

Jet Pump Wear Ring for Thrasher 27" Jet Boats (also fits V3)

Full size servo mounted on servo mount with factory centered steering rod mount assembly - Thrasher 27" Jet Boat

$99.00

Full size waterproof servo assembly for Thrasher 27" Jet Boat ready for install (also compatible with V3)

Adjustable Trim Hardware Set

$19.99

This is a complete harware set for your adjustable trim steering cone assembly. It includes all of the required hardware to rebuild your adjustable trim assembly.

Thrasher V3 Waterproof Receiver

$99.99

Thrasher Waterproof Receiver. Shown with battery tray (sold separately)

Sponson Fins - Set of 4

$29.99

This is a complete set of 4 sponson fins (2 port and 2 starboard) for Thrasher Jet Boats. If you are adding sponson fins to a Thrasher that does not already have a sponson fin kit installed, you will need to purchase a sponson fin kit, which includes these fins as well as mounting hardware.

Lid Pin

$19.99

Stock lid pin for all versions of Thrasher RC Jet Boats

Adjustable Trim Steering Cone

$49.00

Adjustable Trim Steering Cone for Thrasher 27" Jet Boat (Also compatible with V3)

Power Bilge - Continuous

$99.99

This is a replacement for the standard power bilge included in Thrasher 27" Jet Boats (also V3). If you are installing a power bilge into your Thrasher for the first time you will need to also order the installation kit.

ESC - Thasher 27" Jet Boat

$119.99

Thrasher 27" Jet Boat ESC (also compatible with V3)